Peristaltic Pump

Head Speed

0 to 48 RPM

Torque

>3 N-m across full operating range at 115VAC

Speed Stability

0.5%

Speed Adjustment

0.00 to 9.99 RPM in 0.01 RPM increments; 10.0 to 48.0 RPM in 0.1 RPM increments

Flow Rate

0 to 37 mL/min max at 0 backpressure (depending on tubing diameter)

Flow Tubing Diameter

0.25 mm ID – 4 mm ID

Dimensions (W x D x H)

160 x 190 x 275 mm (6.3 x 7.5 x 10.83 in)

Head Speed

0.01 to 48 RPM

Torque

Greater than 3 Nm at any speed below 25 RPM, at or above nominal voltage.

Motor Speed Stability

0.5% for any variation of line voltage, torque, or temperature.

Continuous Speed Adjustment

From 0 to 48 RPM by 0.01 increments up to 9.99 RPM, above 9.99 RPM by 0.1 increments.

Flow Rate Range

Maximum: MP model 40 mL/min (1.8 L/h, 4 mm tubing), HF model 250 mL/min (15 L/h, 8 mm tubing).

Minimum: 0.3 µL/min (0.25 mm tubing)

Maximum Back Pressure

500 kPa for MP models, 300 kPa for HF models

Peristaltic Tubing Diameter

0.25 to 4 mm (id) for MP models, 2 to 8 mm (id) for HF models

Rpm Range

1-100 rpm

# of Channels

1

tubing diameter

3.1-6.4mm

Standard Flow Rates (1, 2, 4, or 8 channels)

0.3 µL/min–30 mL/min at a maximum pressure of 0.5 MPa

High Flow Rates (2 or 4 channels)

1 mL/min–220 mL/min at a maximum pressure of 0.3 MPa

Head Speed

Continuous adjustment from 0 to 48 rpm by 0.01 rpm increments up to 9.99 rpm and by 0.1 rpm increments above 10 rpm

Motor Speed Stability

0.5% for any variation of line voltage, torque, or temperature

Peristaltic Tubing Diameter

Standard model: 0.25–4mm (ID)

High-Flow model: 2–8mm (ID)

Pump Heads

Standard model: 1-, 2-, 4-, or 8-channel heads with 10 stainless steel rollers per head

High-Flow model: 2- or 4-channel heads with five stainless steel rollers per head

Power Requirements

90-132 or 180-264V; 47-63Hz

Dimensions

15 x 17.5 x 18 cm (5.9 x 6.9 x 7.1 in)