| Readability |
0.1 mg / 0.001% |
| Weighing Capacity |
100 g |
| Typical Reproducibility of the Weighing System |
Starting at an initial sample weight of approx. 1 g: ± 0.1%
Starting at an initial sample weight of approx. 5 g: ± 0.02% |
| Method of Measurement |
Thermogravimetric; loss on drying |
| Recommended Moisture Range |
0.001 - 99.999% |
| Heat Source |
Four parallel infrared quartz cylinders |
| Modular Extension |
Optional; up to 4 heater modules connectable |
| Data Printer |
Integrated thermal printer; 40 characters |
| Temperature Range and Adjustment |
30-210°C in one-degree increments |
| Temperature Steps |
Programmable; one or two with selectable ramp rate |
| Standby Temperature |
Standby temperature selectable from 30-160°C |
| Temperature Display |
Display of target temperature and actual temperature during the measurement and in standby mode |
| Display Modes |
Weight loss in mg, % moisture, % dry weight, % volatiles, ppm moisture, ppm dry weight, concentration mg/L |
| Modes of Operation |
Standard, syringe, concentration or 2-phase drying mode |
| Endpoint Determination |
Timer mode; when value falls below a defined weight loss per time unit (%/min); trend shutoff |
| Program |
300 programs; battery-backed memory |
| Data Storage |
Results with statistics of the last 999 measurements: average, SD, RSD, min and max |
| Temperature Adjustment |
Optional set for internal electronic two-point adjustment |
| Adjustment of the Weighing System |
Internal calibration weight or manual calibration and adjustment using an external weight |
| Ideal Initial Weight |
Audio and visual display for programmable weighing of a sample to an initial target |
| Pass-Fail Function |
Programmable target value including limits; pass-fail information at the end of a measurement |
| Display |
Backlit VGA display |
| Real-Time Curves |
Real-time curves of the loss in weight (% or grams) as well of the temperature curve during and after the measurement |
| System Status Indicator Lights |
Two tricolor LEDs (balance & heater) on front of heater module |
| Interfaces |
Serial and Ethernet; USB for service |
| Weighing System |
Monolithic weighing system for high-precision results |
| Dimensions (W x D x H) |
16.3 x 19.5 x 9.3 in. (41.3 x 49.5 x 23.5 cm), modules combined |
| Weight |
22 lb.(10 kg), modules combined |
| Electrical Requirements |
90-250 VAC, 50/60Hz, self-adjusting power supply |
